It is the two-wire serial communication protocol. The Vcc voltage value can be negative or positive to the GND pin. It is also called the primary voltage for ICs present on the Arduino board. V in–It is the modulated DC supply voltage, which is used to regulate the ICs used in the connection. The program is uploaded to the board serially from the computer through the USB cable. This port can be used to power the device from the 5V supply and allows us to connect the board to the computer. USB B-port- The USB Interface is used to plug in the USB cable. Note: Above 12 volts, the board may overheat and voltage below 7 volts might not be sufficient to power the board. The board can be powered by an adapter that ranges between 5-20 volts but the manufacturer recommends keeping it between 7-12 volts. The barrel jack is usually connected to an adapter.
There are three ways to power the Arduino Mega Board:īarrel Jack – The Barrel jack, or 7-12V DC Power Jack can be used to power our Arduino board. Are you a beginner? Can't decide which book to read? Check out this article on Best Arduino Books for beginners How to power the Arduino Mega 2560? RESET Button-It is used to Reset the board, recommended to press it each time we flash some code to the board.
It provides the basic timing and control to the board. This allows it to effectively find a balance between power consumption and processing speed.Ĭrystal Oscillator- The Crystal oscillator has a frequency of 16MHz, which provides the clock signal to the microcontroller. Even if there are any changes in the input voltage of the regulator, the output voltage is constant and steady.ĪTmega2560P : It is an 8-bit AVR RISC (Reduced Instruction Set Computer) based microcontroller that executes powerful instructions in a single clock cycle. The primary use of a voltage regulator is to control the voltage level in the Arduino board. Voltage Regulator-The voltage regulator converts the input voltage to 5V.
0 kommentar(er)
